julianE's latest activity

  • J
    julianE replied to the thread HV series PIC.
    Full agreement about Picaxe, I'm pretty much done with the compiler adventure, it's good to have it as a helper chip to picaxe, for...
  • J
    julianE replied to the thread HV series PIC.
    I finally got around to scoping RA4 with the CLKOUTEN=ON, I'm measuring 2 MHz. After that I went and removed the two WAIT commands and...
  • J
    julianE replied to the thread HV series PIC.
    Will do. Honestly, reason I posted it here is because of sheer level of brilliance, friendliness and kindness. Nothing like this forum...
  • J
    julianE replied to the thread HV series PIC.
    I will give that a try later today. I have some success to report, MPLAB X and XC8 installed and LED blinking away. I will dissect the...
  • J
    julianE replied to the thread HV series PIC.
    I have been using a Vcc of 5V direct but did try it with a 10 ohm in series between 5V and Vcc pin and got same result. I have a .1 uF...
  • J
    julianE replied to the thread HV series PIC.
    I can get the LED to turn on or off when it's connected to 5v directly and programming with pickit3 completes fine. It has a 13 bit...
  • J
    julianE replied to the thread HV series PIC.
    Thanks Goeytex I have tried GCB and PK3 and no luck, as a sanity check i tried a 12F1840 (of course changed #chip for a different pic)...
  • J
    julianE posted the thread HV series PIC in Active PICAXE Forum.
    Looks like the microchip famine is passing, I just got a big shipment of 08M2 chips, albeit they are labeled 12F1840, I have to be...
  • J
    julianE replied to the thread Solar powered Pond pump.
    I bet there will be a "one weird trick" that will allow a car to drive coast to coast on a single lithium sulfur battery.
  • J
    I had to reach out to the Positron to get the flashing working with my chip. Had a response within a day and the chip is flashing away...
  • J
    Well, I tried the OshonSoft, nice that he let's you try before buy, led blinking away in 10 minutes time. I'm not sure how much better...
  • J
    There is a way to get sleep to work in GCB using watchdog timer it's a pretty involved subroutine, I'm liking your method of just...
  • J
    I have the latest Positron and have struggled to flash an LED, after many attempts i have it working but very poorly. I'm very...
  • J
    I perused the positron manual and it's very much like picaxe, serial communication looks almost as good and it has sleep which is a pain...
  • J
    Thanks very much for your suggestions. I too have managed to get things working in GCB but it's not easy, lots of trial and error and it...
Top