Recent content by jims

  1. J

    What are the maximum limits of peeking/poking address in SLOTS ??

    I cut i back..Here's a condensed version..
  2. J

    What are the maximum limits of peeking/poking address in SLOTS ??

    The file was too large..& wouldn't upload.. SORRY!
  3. J

    What are the maximum limits of peeking/poking address in SLOTS ??

    Someone...probably Hippy...sent this to me a couple of years ago. Will it help?
  4. J

    PE6 Operating Manual & SERTXD hiccup

    Thank you...Buzby..
  5. J

    PE6 Operating Manual & SERTXD hiccup

    Buzby....I'm sort of a "programming novice". Just what is a......"back-to-front OS"?? Thanks...
  6. J

    SPE030 Speech Module Problem

    I used an EMIC2 TTS module to receive and speak status data from a robo car a couple years ago. Don't remember much about it. Would this work?? JimS
  7. J

    Brain hurts..anyone bored..

    Has "Fritzing" fallen from favor??
  8. J

    Best starter kit?

    Thank you!!...my education is now complete... JimS
  9. J

    Best starter kit?

    RNovember....I'm math is not good enough to understand what "I would be MMMMMMMMMM ". is in decimal. Please help.. Dilbert's math??? Thank you, JimS
  10. J

    Best starter kit?

    Aries..expressing the age in HEX is sort of like "putting lipstick on a pig".
  11. J

    Best starter kit?

    I've used the AXE091 Development board for several years. Purchased a mixture of Picaxe chips and other components when needed. Found that it is very versatile and well documented product
  12. J

    hell.p 20m2 pin c.7

    How do you get past having a "syntax error" with no "endif'" ? Jims
  13. J

    how control cr servo with pwm?

    Can someone help me get started with some hints on how to control a cr servo with pwm? I want to use the ultra command for range and it conflicts with the servo command. I think that I may have been here before but can't remember..Thank you, JimS
  14. J

    hoe use sertxd?

    Thank you inglewoodpete .....
  15. J

    hoe use sertxd?

    F8 key it is...Thank you.
Top