Hi! sorry I was delayed by my job; thank you all again for your help.
So here is what I did:
1) I replaced the 9V battery with a 12v 1A PSU
2) Using my multimeter I measured the voltage regulator and PICAXE socket without the chip and got a 4.34v reading (don't know if that's enough)
3) Re...
Thank you! I tried the hard reset but I get the same response:
Verification error - 0x00 transmitted but nothing received at byte 0.
I also tried to clear the program; same result.
I'm using a fresh 9v battery, and I measured the 7805 and it's a perfect 5v.
I've seen the same issue in older...
Hello! I'm having an issue using a TRENDNET TU-S9 (prolific chip) USB to RS232 adapter.
I'm able to read the firmware of the chip, but I cannot download any data.
The loop test pass perfect.
When I do the voltage test, it reads -6.4v with the led off and 6.4v with the led on. I removed the...
Hello guys,
I've built on a breadboard the download circuit for a Picaxe 8m2 and I can't get it to download a program or read the firmware BUT it does give me the message "This is your picax..." perfectly well. Some parameters:
- I've added a decoupling capacitor in the power supply.
- I'm...