Recent content by golfnut

Hi trying to make a xmas novelty for the kids.. I can play a sound/tone on my HW. But I cant play the rudolf tune anywhere other than in the logicator. I get clicks for the tune in flasher mode - nothing in no output. So is the tune just in logicator am I wasting my time!

Hi, Im using an axe 14. I can see the chip has lots of inputs and outputs. I would like to play the rudolf tune - no problem whilst at the same time use another output pin to flash his nose. The Logicator graphic flowchart deletes the parallel process line to the flash routine. Is this...

Sorry to be a useless. I jumped the gun and plugged my shiny rev ed usb to 3.5mm cable into my win 7 professional laptop. Im in a hole with it for a couple of hours. I put the driver in off the rev ed site. When I plug the lead in - I get the cant find the driver message. The cable shows...

Hi, I am looking at getting the counter value from a three byte wide counter into a 20x2 . So I need to get the info off 12 lines - I want to keep it simple but should I be adding a mux device to each byte in sucession?? gn ps ive used i2c one time and of course getting register values was...

Not great on this, hence the post.. Ive a factor to be held permanently in code and its 1333333.33 this forms the numerator every time I do a division conversion on a counter result. A valid conversion may be :- 1333333.33 / 4092 hopefully would give 325.8 -I would like to display 326 on...

Hi its while since Ive geen on here - hope your all good already spied a few usual suspects, you know who you are. As the nights are drawing in my attention seems to turn to projects and learning to ham more code. This years challenge is to make a timer with a start and stop - convert the...

Embarking on ambitious project, to me it is unclear if it can be done with a picaxe. I want to make a 'pretty-accurate' Temperature probe/device based on the Analog Devices ADT7410. I need to read I2c register data in from it, and do some math conversion and Display temp on 7segment display in...

Hi, I have made a kit from reved, a simon says game... I have an impatient daughter wanting to give it a try!!!. I attempted a download of the simon says.bas from the samples folder of the picaxe suite and the sytax checker informs me there is a bug in the code.. It says this.. and wont let me...

Hi Im a nubie too, not good at this stuff. Ordered some HW and 08m chip. Im helping an old boy at my model flying club. He likes free flight models - you start the motor and throw. A few seconds later after the climb the motor stops and you get the short floaty unpowered flight, the model comes...