Goeytex's latest activity

  • G
    Goeytex replied to the thread Hippy status, rev 2.0.
    I can't agree with that either. FTDI are the best available IMO. I play it safe by sourcing critical components/devices from...
  • G
    Goeytex replied to the thread Hippy status, rev 2.0.
    Another little known adapter is actually manufactured by FTDI and is the UMFT234XF ..... UMFT234XF DataSheet This adapter uses the...
  • G
    Goeytex replied to the thread Hippy status, rev 2.0.
    Fakes/Counterfeits seem to work perfectly until you try to use advanced features , like changing the power descriptor, or inverting the...
  • G
    Goeytex replied to the thread Wireless programming ?.
    Hi Stan, The LC-1000/2000PA modules worked fine as I recall. These operate as a transparent UART. I did not pursue past a working...
  • G
    Goeytex replied to the thread Hippy status, rev 2.0.
    Welcome back hippy. You were obviously missed. Genuine FTDI Best of the best except for the cost. No external inverter required...
  • G
    I would only agree if you mean interpreted BASIC. There are BASIC compilers available for 8-Bit PIC and AVR that compare quite favorably...
  • G
    If I am not mistaken most controllers respond to a throttle voltage from about 0.8V to 4.0V. Where 0.8V just starts the motor and...
  • G
    Is the motor controller the original one that came with the Grizzly? Did you get the Grizzley new? If that is the behavior from a new...
  • G
    Goeytex replied to the thread Download Circuit Question.
    In regards to the 22K series resistor for Picaxe Programming, it CAN eliminated if all you do is Program with a TTL adapter, but I...
  • G
    Goeytex reacted to wapo54001's post in the thread Farewell with Like Like.
    @premelec, I hope you will visit the forum again to know about the people here that you have affected with your news. Yours and my first...
  • G
    Goeytex reacted to julianE's post in the thread Farewell with Like Like.
    Very sad to hear premelec's farewell. Also, saddened to hear how many of our community are at the same point of life. I very much hope...
  • G
    Goeytex reacted to erco's post in the thread Farewell with Like Like.
    @premelec: We are all saddened to hear that, you have been a steadfast pillar of this wonderful online community, and you have helped...
  • G
    Goeytex replied to the thread Farewell.
    @premelec You have helped many folks here, I am one. You will be missed. I may not be too far behind you. Thank You and Best...
  • G
    Goeytex replied to the thread Absolute encoder programming.
    @chaymoss Perhaps you could describe your actual application? What type of motor ? Brushed? Brushless ? Stepper? Geared Stepper...
  • G
    Goeytex replied to the thread Servo help.
    If it stopped working with no changes on your part then there has been a failure unrelated to the code. If you changed something then...
Top