Recent content by coolmandan1

Hi all, I am having some problems with the download circuit on the PICAXE 28-X1. One part of the manual tell me to connect pin 3 of the download socket to the 0V pin of the chip. And another part tells me to connect pin 3 of the download socket to the 0V rail of the circuit!?!?! I'm really...

Hi, Hi again everyone. I want to connect a thermistor to the ADC port of a PICAXE 28X-1. But on looking at the 'Interfacing Circuits' data sheet i discovered that you have to add a resistor after the thermistor and connect it to 0V. I am fine with doing this but was just wondering what it was...

Hi, I wanted to connect an LED to the output of a PICAXE 28X-1 chip and worked out the series resistor value to be about 80 ohms. But when i looked in the manuals it suggested that i should a 330 ohm resistor. I am not sure which one i should use?? Thanks, Daniel

Hi, i know this may be a silly question but what is the output voltage of an output pin on the PICAXE 28X-1. I think it is the same as the supply voltage but just want to be sure!!!

Hi, I was wonderinf if anyone had made a 'police siren' sound using the Tune Wizard for PICAXE 08M. If anyone can help or suggest that i do something else it would be appreciated. Thanks, Coolmandan1

Hi, Please could someone tell me what chip i am using. Here is the text that is printed on the top of it: PIC16F627A -I/P (symbol) (symbol) 06285DA It has 18 pins. If you need anymore information please contact me. From coolmandan1 ,thanks

Hi, I was wondering if it was possible to tell the picaxe chip that if an input is 'high for 3 seconds, then low for 1 second, then high again for 4 seconds, to then carry out a goto command only if that input has been high/low for the amount of seconds stated. If you don't understand what i am...

Hi, When i try to type a command such as 'count', the software says 'ERROR: Count command not supported in this mode'. I wondered if it is possible to change the mode that my PICAXE software is working in. If it is any help, in the bottom left hand corner of the PICAXE Software it says...