Hi All,
I am considering a project involving writing to a small Colour TFT display
My purchase choices are either serial or parallel bus versions (at around £5 each)
I can see from the command info that Picaxe 28x2 can clock data in at 1/4 clock frequency, I shall be using 25mhz xtal so my...
I have done a huge amount of work using a 28x2 @ 100mhz Transmitting lots of DMX data within quite a complex application.
I have been running this in a LIVE situation for several months now and is VERY stable :@)
My head is now turning towards DMX RECEPTION
I havent tried this yet, but this is...
Hi, I have written some code for 28x2 so that I can use the AXE27 USB/serial lead for data on the Serin/Serout pins (as per programming)
When I send a byte from the Programming Editor Terminal program, my picaxe appears to RESET
I have tried the disconnect/reconnect in various different ways...
Is there a way that picaxe chips can be programmed without having the software visible ?
My ideal situation would be to have a pre-compiled version of my software that I can load into an application and then connect up and program chips
This would be really useful for other people to update...
I have a rather complex program (too complex to post here)
But basically if I set up the following code everything runs fine
#picaxe 28x2
SetFreq em64 ' set micro to run at 64 mhz !
adcsetup = %0000000000000001 ' set adc to pin 0
tmr3setup %00110011 ' timer3 set to 1/8 prescaler
main...
Hi All,
As a continuation my my recent development on DMX lighting projects (which are going full swing) I have started work on a 08M2 based laser light show.
Note : I understand the risks involved with working/demonstrating lasers, and been reading the H&S details
The light show PCB will be...
Many moons ago, Hippy published a way that X2 devices can output DMX lighting data, I decided to try this for myself and it worked perfectly !!
Since this time I have developed a totally unique & simple DMX lighting control product (simple electronics / complex software) that can run Fader...
Here is something I found in an archive directory. I'm not sure if anyone will find it useful, but its there if you need it..
<code><pre><font size=2 face='Courier'>
'
' **************************************
' **** Revised State-Driven Engine ****
' **************************************
'
'...