Recent content by ausiey

  1. A

    Project with Picaxe28*2 randomly starts on its own

    Hi Thanks , yes the caps near the power supply fixed the problem, thanks again
  2. A

    Project with Picaxe28*2 randomly starts on its own

    Thanks for your assistance a few caps, were installed near the power regulator and it has settled
  3. A

    Project with Picaxe28*2 randomly starts on its own

    Thanks for your assistance
  4. A

    Project with Picaxe28*2 randomly starts on its own

    Thank you for your assistance, I included capacitors close to the chip power pins and it seemed to have overcome the fault, thanks again
  5. A

    Project with Picaxe28*2 randomly starts on its own

    Thank you for your assistance, I included capacitors close to the chip power pins and it seemed to have overcome the fault, thanks again
  6. A

    Project with Picaxe28*2 randomly starts on its own

    Thank you for your assistance, I included capacitors close to the chip power pins and it seemed to have overcome the fault, thanks again
  7. A

    Project with Picaxe28*2 randomly starts on its own

    Thanks Bill, I will take your suggestion on board. John
  8. A

    Project with Picaxe28*2 randomly starts on its own

    Hi I will organise a photo of the cct and the control board ASAP. Thanks for your reply
  9. A

    Project with Picaxe28*2 randomly starts on its own

    Hi I am using A RKP28PROJECT PCB that has a download socket, I assume it has the resistors installed. I will try your suggestions and let you know how it works out. I do believe that the triggering is been done by some electrical interference . FYI, As another clue to the fault. When the...
  10. A

    Project with Picaxe28*2 randomly starts on its own

    Hi Allan Yes it is permanently powered directly from a 12 volt battery with a regulator that supplies the 5 volt rail, this is directly connected to RKP28 PROJECT PCB, wher the PICAXE28*2 chip is mounted, i assume that the PCB has a pull down resistance on the programming socket. The program...
  11. A

    Project with Picaxe28*2 randomly starts on its own

    Hi No it is not located in a car, It is stationery project, I am going to try a few ideas that have been suggested and i will let you know how it works out, thanks
  12. A

    Project with Picaxe28*2 randomly starts on its own

    Hi, Thank you for your reply I will try and see if it solves the problem and let you know of the outcome.
  13. A

    Project with Picaxe28*2 randomly starts on its own

    * Yes the picaxe does drive a inductive load via a relay. But every time it happens all inductive loads are in the off state. * No capacitors close to the pic axe power pins direct connection to battery, what do you recommend? * The download connection is done directly on the board supplied, i...
  14. A

    Project with Picaxe28*2 randomly starts on its own

    Hi, recently i built a project with a Picaxe*2 chip and randomly the project activates or starts on its own, it has switches as inputs wired in cat 5 cabling to various areas no longer than 3 mts away from the main board. This random activation may happen once a week, the project is run on a 12...
  15. A

    Technical help, new user to picaxe

    Hi Nick12ab I think I have uploaded and attached the pic's you required, I will let you know about the current reading another day.
See more
Top